A) Insulating Glass
B) Low-emissivity (low-e)
C) Tinted Glass
D) Float Glass
Correct Answer
verified
Multiple Choice
A) 6, 10 or 12 inches on center
B) 8, 12 or 18 inches on center
C) 12, 16 or 24 inches on center
D) 10, 12 or 14 inches on center
Correct Answer
verified
Multiple Choice
A) One
B) Two
C) Four
D) Six
Correct Answer
verified
Multiple Choice
A) It is typically conducted within the first three months for the contract to fix any problems that may arise after moving in.
B) Focuses only on the structure of a building and how it is settling and normally not the interior finishes.
C) It is the evaluation of the architect, designer, sub-contractors and contractor, on how the project performed.
D) Involves the evaluation of the opinions from the people that use the building and how well the building matches the user's needs. It identifies ways to improve performance and building design.
Correct Answer
verified
Multiple Choice
A) The measurement strength of glass
B) The measurement of reflective glare
C) The measurement strength of the window frame material
D) The measurement of heat resistance
Correct Answer
verified
Multiple Choice
A) LED
B) Halogen
C) Incandescent
D) Fluorescent
Correct Answer
verified
Multiple Choice
A) Wood used for baseboards, railings, chair rails, picture and corner moldings.
B) Makes use of joinery of fine quality. It is used in the construction of built-in cabinets and shelves.
C) Ready-made products that are manufactured a woodworking plant or mill.
D) Custom made finish lumber made by hand piece by piece.
Correct Answer
verified
Multiple Choice
A) Towel bars cannot be used because they are not long enough for use as a grab bar.
B) A grab bar needs to be between 1 1/4" and 2" in Diameter and support a static load of 250 pounds.
C) A towel bar should not be used in the shower as the finish is not made for water.
D) The finish on a towel bar does not have enough grip strength in the finish to qualify for a grab bar.
Correct Answer
verified
Multiple Choice
A) Overhead above the vanity sink.
B) On each side of the mirror, mounted at eye level.
C) A single light in the middle of the room.
D) One light in the middle of the room and one in the shower area.
Correct Answer
verified
Multiple Choice
A) Yarn Dyeing
B) Solution Dyeing
C) Cross Dyeing
D) Piece Dyeing
Correct Answer
verified
Multiple Choice
A) All receptacles must be protected by ground-fault circuit interrupters.
B) At least one GFCI Protected must be installed within 36" of the outside edge of the lavatory.
C) A receptacle can be installed within a shower or bathtub space if the plug is above 36"
D) Switches shall not be installed within wet locations in tub or shower spaces or within reach unless part of the listed tub assembly.
Correct Answer
verified
Multiple Choice
A) Fire Resistance testing for materials used in the structure of a building
B) Tests Color transfer from fabrics through rubbing.
C) The purpose of this test method is to assess the electrical resistance of flooring using similar weights and pressures.
D) A regular program of testing insulation resistance in a commercial building
Correct Answer
verified
Multiple Choice
A) Seepage
B) Capillary
C) Perk
D) High water table
Correct Answer
verified
Multiple Choice
A) 2
B) 3
C) 4
D) 5
Correct Answer
verified
Multiple Choice
A) It is the nonstructural material that lays under the flooring as a vapor bearer to the outside elements.
B) It is the drywall layer underneath vinyl flooring so there is a smooth finish to work with.
C) It is the structural material that spans across floor joists, and a base for finished flooring.
D) It acts as the cushion layer for carpeting when it's laid over concrete.
Correct Answer
verified
Multiple Choice
A) The walls are collecting so much dust on the surface it looks like chalk.
B) The paint is powdering on film surface.
C) The color of the paint is getting lighter in areas.
D) The drywall is showing through the paint in places due to poor application.
Correct Answer
verified
Multiple Choice
A) Heat-treated nonflammable materials
B) Wood frame materials
C) Approved noncombustible materials
D) Heavy timber
Correct Answer
verified
Multiple Choice
A) 36 inches
B) 42 inches
C) 54 inches
D) 60 inches
Correct Answer
verified
Multiple Choice
A) 6 inches to 10 inches
B) 12 inches to 15 inches
C) 18 inches to 21 inches
D) No restriction
Correct Answer
verified
Multiple Choice
A) Planks
B) Veneers
C) Laminate
D) Plywood
Correct Answer
verified
Showing 161 - 180 of 191
Related Exams